PUMPA Presscontrol PC-59 pressure control unit

Description

• Automatic start and stop of the pump
• Automatic stop in case of lack of water
• In the event of a power failure, the pump automatically restarts as soon as power is restored
• Manual forced restart
• Overpressure protection, automatic stop when exceeding 10 bar
• Automatic restart in case of lack of water, the interval for restart is 1 minute, 30 minutes, 1 hour and then over and over.
• There are 2 operating modes built-in:
  • Mode 1. "Prescontrol" function with the possibility of setting the switch-on pressure in the range 0.5-6 bar.
  • Mode 2. "Pressure switch" function with the possibility of setting the pressure which will switch the device on and off (must be operated with a pressure vessel, set the pressure in the vessel to 90% of the switch-on pressure.)

Sufficient flow must be ensured to switch between mode 1 and 2. Press the "Function" button for 6 seconds to switch from mode 1 to mode 2. To set mode 1, repeat the procedure.

Sufficient flow must be ensured at all times during the mode change.