WILO HiControl automatic pump control system

Electronic control and regulation accessories. The Wilo HiControl 1 series is used for borehole pumps to enable automatic operation. Wilo-HiControl 1 protects the pump against operation with low volume flow. Thanks to a volume flow sensor and pressure sensor, Wilo-HiControl 1 automates the pump between two values, the start-up pressure and the shut-down volume flow. If the pressure in the network is lower than the start-up pressure, Wilo-HiControl 1 starts the pump. The pump continues to operate until the volume flow falls below the value of the shut-off volume flow.

The interior small container prevents water hammering and cycling.

The Wilo-HiControl 1-EK version with electric cable and built-in socket reduces the time required for installation through direct connection to the pump and to the current.

Wilo-HiControl 1 can be mounted on surface pumps or connected to submersible pumps for domestic water supply.

Special features

• Simple installation
• Especially compact design makes it suitable for many types of installation locations
• High operational reliability due to electronic fault signal
• Protection of the connected pumps due to built-in protection against low water levels
• Simple operation due to clear operating state display
• No additional diaphragm pressure vessel required
• Perfect corrosion protection, due to rust-free materials
• Wired ready-to-plug for fastest installation.

Inline version with input and output in vertical axis and uniform thread connections, suitable for direct connection to the pump housing or wall surface installation with a wall bracket (accessories).

Note

The HiControl 1 may be installed only in vertical position with the output at the top.